Engine Skeletal Mesh LOD Import & Setup

From Tripwire Interactive Wiki
Revision as of 00:43, 26 September 2013 by Davidhensley (talk | contribs) (Created page with "Click the Cycle through the LOD mesh levels to get to LOD1 The button is shown here: File:CycleLODS.jpg Then go to File > Mesh LOD Import and select your LOD1 .psk Cli...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Click the Cycle through the LOD mesh levels to get to LOD1

The button is shown here:

Then go to File > Mesh LOD Import and select your LOD1 .psk

Click the Cycle through the LOD mesh levels to get to LOD2

Then go to File > Mesh LOD Import and select your LOD2 .psk

Click the Cycle through the LOD mesh levels to get to LOD3

Then go to File > Mesh LOD Import and select your LOD3 .psk

Check your lod settings and make sure they match the following settings

Finally click the Redigest LODs button shown below

Save your package!