Engine Skeletal Mesh LOD Import & Setup: Difference between revisions
Jump to navigation
Jump to search
Davidhensley (talk | contribs) (Created page with "Click the Cycle through the LOD mesh levels to get to LOD1 The button is shown here: File:CycleLODS.jpg Then go to File > Mesh LOD Import and select your LOD1 .psk Cli...") |
(No difference)
|
Latest revision as of 00:43, 26 September 2013
Click the Cycle through the LOD mesh levels to get to LOD1
The button is shown here:
Then go to File > Mesh LOD Import and select your LOD1 .psk
Click the Cycle through the LOD mesh levels to get to LOD2
Then go to File > Mesh LOD Import and select your LOD2 .psk
Click the Cycle through the LOD mesh levels to get to LOD3
Then go to File > Mesh LOD Import and select your LOD3 .psk
Check your lod settings and make sure they match the following settings
Finally click the Redigest LODs button shown below
Save your package!